Fence extenders for dogs -You may have already decided that an electric dog fence is the perfect solution for your pet problems. However, there are a few things you need to do before you actually buy electric fence kit. First, you must take your dog to a veterinarian to make sure it can withstand an electrical fence. This can cause unnecessary stress for some smaller dogs and those with some hygiene requirements. Your next task is to learn how to put the electrical fence in place to ensure it works properly for you and your pooch. An electric dog fence can be handy to install when you have a pet dog. This type of fence basically keeps your dog in your yard without the need for a large, intrusive fence on your property. In some areas, setting up a fence may be prohibited, for example in some developments, so an electric dog fence is the only option.
Instructions for installing electric fence extenders for dogs walk the whole perimeter of your property and figure out exactly where you want the electric dog fence located. When you go, place small red flags by a few meters so you know where you dig. Place a wide, straight edges shovel in the ground where you plan to dig down the barbed wire. Slide it about 2:59 inches in the ground. This will create a slot just wide enough for the thread. If you drive the fence along a driveway or other cement path, you must use a saw to make this line. Connect any wire you will need to do around the entire property. You can add lengths of thread by stripping away about ¾ inches of coating on each thread end and using waterproof connectors to connect them.
12 Photos Gallery of: Electric Fence Extenders for Dogs
Bury the thread. Simply slide the thread into the slots you made. The thread should be 2:59 inches in the ground. Cover grass surfaces with dirt or soot and dense cement areas with joint seal gun. Be sure that no thread is visible when done. Install the transmitter for your fence inside your garage or building. It must be in a well-protected dry area near an electrical outlet. Most transmitters come with a pair of screws that you can use to mount it on the wall.
Run the excess wire in the shed or garage so you can connect it directly to the transmitter. This is what will give the fence extenders for dogs its power. You can connect the two cables to the base of the transmitter. Connect the transmitter to an electrical outlet and test the fence. Place the receiver on the dog’s collar and put a collar around a sensitive area of the body, such as the throat or wrist. Move over the underground thread you buried to test shock. You should feel it, but there should be no pain sensation. If there is, you know the setting is too high for your dog. Remember, your dog is likely to be more sensitive than you to shock; Plus, your dog is not going to know the shock comes.Tag : fence extenders for dogs